Delgine 3D Tools & Content DeleD Community Edition
Forums
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Better control of the Extrude command

 
This forum is locked: you cannot post, reply to, or edit topics.   This topic is locked: you cannot edit posts or make replies.    DeleD Community Edition Forum Index -> DeleD Feature Requests
View previous topic :: View next topic  
Author Message
Lascar
Member


Joined: 28 Feb 2010
Posts: 79
Location: Cornwall, England

PostPosted: Tue Apr 13, 2010 1:07 pm    Post subject: Better control of the Extrude command Reply with quote

Would it be possible to have numerical control (X, Y, Z translation) when using the Extrude command?
I have found myself wanting this on many occasions Crying or Very sad
Unfortunately, if I try to do it accurately (zoom in) it jumps backward and forwards several times and it takes several seconds and lots of fiddling to get it in the right position.
The only other way around this has been to extrude then use the move command to reposition the extrusion.
This is obviously increasing the time needed for the work, to twice or even three times as long.
So work-wise and time-wise, I think this would be a good improvement - if it can be done Smile
.
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
This forum is locked: you cannot post, reply to, or edit topics.   This topic is locked: you cannot edit posts or make replies.    DeleD Community Edition Forum Index -> DeleD Feature Requests All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum